搜索资源列表
5_3_8
- In This paper, the authors propose a Sensorless Direct Torque and Flux Control (DTFC) of Induction Motor (IM) using two approach intelligent techniques: Mamdani Fuzzy Logic (FL) controller is used for controlling the rotor speed and Artificial Ne
Paper-1-Sebirien-2011
- Speed & Flux estimation by Extended Kalman Filter for Sensorless Direct Torque Control of Saturated Induction Machine
Low-Voltage-Ride
- 详细说了双馈风机三相短路时的情况，并且着重分析了短路电流的表达形式以及最大值出线时刻，在此基础上提出了Crowbar电阻的取值方法。-In case of three-phase short circuit fault occurring at the terminal of a doubly-fed induction generator ( DFIG ), the rotor current characters of DFIG are analyzed from the viewpoint
Rotor-Time-Constant-Identification
- 基于转子磁链模型的模型参考自适应方法，用于辨识转子时间常数-Rotor Time Constant Identification in Vector Controlled Induction Motor Applied Flux Model Reference Adaptive System (MRAS)
oriented_vector_control
- 异步电机间接矢量控制Simulink仿真模型，带有转速外环和Iq、Id两个内环，转速和负载指令阶跃变化，3/2变换为恒幅值变换，不包含弱磁控制，磁链指令为恒值。PWM调制算法采用空间矢量调制（SVPWM）。 -Indirect induction motor vector control Simulink simulation model with speed outer and Iq, Id two inner ring speed and load instructions step c
Asynchronous_motor_subdivision
- 传统异步电机直接转矩控制多采用六边形磁链控制或六区间的圆形磁链控制，容易造 成转矩和磁链脉动过大，限制了其实用范围。针对此缺陷，本文采用矢量细分的方法，将传统的六电压矢量和六扇区细分为十二电压矢量和十二个扇区，制定了相应的矢量开关表，并通过 MATLAB 对其进行了仿真实验。仿真结果表明，基于矢量细分的异步电机直接转矩控制能够有效改善磁链轨迹，减小转矩脉动，提高系统控制性能。 -Conventional induction motor direct torque control multip
motor_observer_final
- Rotor Flux and Speed Observers for Induction Motors
IM
- modeling of Induction Motor using, voltage, flux and torque equations
SV_control
- 异步电机空间矢量控制，使用了磁链观测器，虽然是开环观测 但是性能依然良好-Space vector control induction motor, using a flux observer, though, is the open-loop observer but the performance is still good
FLUX2
- THIS PAPER IS ABOUT AXIS FLUX AND DIAGNOSIS FAULT IN INDUCTION MOTOR RARE
21__430_436
- The generating systems use Doubly-Fed Induction Generators (DFIGs) to achieve high conversion efficiency and to reduce the installation cost. This paper presents a modeling and Maximum Power Point Tracking (MPPT) control method of DFIG-based vari
Direct-torque-control
- 随着异步电机开始在交流调速领域占统治地位，针对高性能异步电机的调速系统 研究得到广泛关注。特别是 20 世纪 80 年代直接转矩控制（DTC）的出现，以其简洁高 效的控制方式，进一步提高异步电机的性能。但传统 DTC 存在转矩和磁链滞环宽度使 得稳态时也会产生转矩脉动。因此高性能控制需要窄的滞环宽度,相应要求高逆变器开 关频率。大功率场合下必须低开关损耗和良好转矩控制性能，传统 DTC 难以同时满足 需求。 -With the beginning of the AC in
vector-control
- 异步电机矢量控制程序，dsp2808、dsp2812，32变换，22变换，速度检测，磁链观测等模块均有-Induction motor vector control program, dsp2808, dsp2812, 32 transformation, 22 transformation, speed detection, and other modules are flux observer
vector-control
- 异步电机矢量控制程序，dsp2808、dsp2812，32变换，22变换，速度检测，磁链观测等模块均有-Induction motor vector control program, dsp2808, dsp2812, 32 transformation, 22 transformation, speed detection, and other modules are flux observer
ACdrivervector
- 异步电机矢量控制simulink仿真图，包括电压模型电流模型磁链模型-Induction motor vector control simulink simulation, including voltage model current model flux model
DFO_IM_S
- matlab simulation of diredt rotor flux oriented vector control of induction motor mith matlab code mmmmmmmmmmmmmmmmmmmmm
fluxvector
- flux estimator in indirect field oriented control induction motor control
article-Hamid-A.-Toliyat
- In this paper, direct torque control (DTC) of fivephase induction motor is developed. A novel DTC scheme is proposed, where fast torque response with low ripple in the stator flux and torque of five-phase induction motor can be achieved. In c
article-Rotor-Field-Oriented-Control-of-Five-Phas
- This paper presents an application of rotor field oriented control (RFOC) to a five-phase induction motor with the combined fundamental and third harmonic currents. Based on the motor model developed in a new d,q, n reference frame, the compl
statorflux
- In this paper an approach to estimate the speed and the stator flux linkage of a three Phase induction motor by means of an algorithm using dSPACE is proposed. Emphasis is given on reduction of the problem of saturation associated with the pu